|
|||||||||
| Winterstone has a wide range of products. If you can not find what you need on this site, contact us ! | |||||||||
 |
Products specificities
Functional characteristic of segments
|
Diameter |
Application range |
Infeed depending on material |
|
900 - 3500 mm |
Large circular sawblades, machining of raw blocks and work from solid |
5- 50 cm step cutting |
|
500 - 800 mm |
Solid machining, massive billet cutting |
5- 35 cm |
|
300 - 500 mm |
Trimming facade slabs and other slabs |
5- 15 cm |
|
Framesaw |
Frame sawing machine, machining of raw blocks, facade slabs and solid billets |
8 - 60 cm/h |
Core material for blades
Up to a diameter of 500mm, mostly close-pitch cores are used; from 500 to 800mm mostly widely spaced toothed cores; for larger diameters, almost exclusively widely-spaced toothed cores.
The abrasive materials cause a very high wear rate on the steel core during the cutting process, so that the teeth of the core tend to become "pointed". There are some materials, such as basalt lava or coarse-grained sandstone, where the number of possible re-tippings is reduced to between three and five.
Segmented Sawblade
The answer to these problems is the segmented sawblade available exclusively from WINTERSTONE. This core minimises the risk of accident and increases the number of possible re-tippings. It prevents tooth thinning. At the same time, it reduces noise level by about 12dB.
There are several types of core available form WINTERSTONE simply for noise reduction, for use on less abrasive materials. For all diameters from 700mm upwards, we recommend the TECHNO core, for reasons of cost.